Should you be investing in a stair with balusters in a contrasting material, like painted balusters on an oak stair, questions will likely arise concerning the finishing of the stair. “Should my painter finish the balusters separately from the stair, then have the balusters fitted when the stair is completed?

Below are a few points to consider with Stair Company Near Hamptons: Your painter will usually choose painting the balusters before installation. This enables them to be sprayed rather than brushed and eliminates a lot of “cut-in” work.

Painting balusters separately does mean the stair installers will need to revisit the site, eliminate the railings and install the balusters. You will have charge for this “second trip” for the jobsite. You will have to remember to schedule this “second trip” in coordination with all the completion of the finish.

Leaving your balusters out for painting implies that they are more inclined to be lost or stolen during this time. You may be in charge of balusters left in the jobsite. When the painted balusters are finally installed, you will have additional “touch-up finishing required in the rail joints. Holes will need to be filled and stain and complete re-applied for the last finish.

Plan installation of your hardwood stair for after your drywall has been taped, sanded, and primed. The drywall process can cause damage to the stair. Drywall mud and paint overspray can make the stair finishing process very difficult and may also make desired results impossible to attain.

Most hardwoods are a wide open grain wood so when dirt gets a part of open grain it is quite hard to remove, even with sanding. This may use a negative effect on the appearance and texture of the finish. Care must also be taken to guard the stair from dirt and mud.

Never Cover Hardwood Stairs With Plastic. Plastic will not allow airflow, trapping moisture underneath and resulting in the wood to grow and contract. This expansion and contraction causes the wood joints to open up up and might cause the wood to crack.

The environmental conditions indoors are critical to the quality of the stair. Hardwood lumber has become dried by way of a very controlled process to an industry standard moisture content of 6 – 8%. This matches the moisture content vcbxbf the normal home and allows the wood to keep stable under normal conditions.

In cold climates, whenever a property is heated to a high temperature in winter, air may become very dry, resulting in the wood to shrink. This shrinkage will make cracks visible in the wood and joints can start to start up. Subjecting a stair to high levels of heat is much like putting it inside an oven and will accelerate the deterioration from the stair.

All hardwoods should be sealed on all sides to retard movement and protect from exposure to elements and damage. It is strongly recommended to seal wood immediately.